Introduction
This test was carried out on black aluminum business cards to verify whether the GM-100 laser could complete the required marking effect within the customer’s expected processing time.
The customer required the marking time to be as short as possible and not exceed 4 minutes.
1. Test Requirement
The customer’s main requirements were:
-
black aluminum business cards
-
Complete the marking as quickly as possible
-
Keep the processing time under 4 minutes
The material size recorded in the source sheet was 80 × 54 mm.
2. Test Goal
The goal of this test was to confirm whether the GM-100 fiber laser could achieve a clear marking effect on black aluminum business cards while keeping the processing time within the customer’s requirement.
The key target was:
-
Required time: less than 4 minutes
-
Actual recorded marking time: 2 min 10 sec
3. Machine and Material Setup
|
Item |
Test Information |
|---|---|
|
Machine type |
Fiber laser |
|
Machine model |
GM-100 |
|
Software |
Ezcad2 |
|
Material |
Black aluminum business card |
|
Material size |
80 × 54 mm |
|
Process |
Laser Marking |
|
Test result |
Good |
|
Customer feedback |
Satisfied |
4. Laser Parameter Used
The source sheet confirms the machine, software, material, size, and marking time. However, the exported source sheet does not include readable values for detailed laser parameters such as speed, power, frequency, hatch, or pass count.
|
Parameter Item |
Value |
|
Marking time |
2 min 10 sec |
|
Speed |
1200 |
|
Power |
15% |
|
Frequency |
100 |
|
Pulse width |
200 |
5. Test Result
The black aluminum business card was marked successfully with the GM-100 laser.
The recorded marking time was 2 minutes 10 seconds, which met the customer’s requirement of completing the process within 4 minutes.
The test result was marked as good in the source sheet, and the customer feedback was recorded as satisfied.
6. Test Conclusion
This test confirmed that the GM-100 laser can be used to mark black aluminum business cards with a good result.
Using EZCAD2 software and the standard GM-100 configuration, the test was completed in 2 minutes 10 seconds, which was within the customer’s required processing time of less than 4 minutes.
The final result was marked as good, and the customer feedback was satisfied. This setup is suitable for black aluminum business card marking applications where clear marking quality and controlled processing time are required.
