Introduction
This test used a UV Pro 5W UV laser with Raycraft software to mark an agate sample. The goal was to check whether the machine could create a clear decorative pattern on the agate surface. The total marking time for this test was approximately 20 min.
1. Test Goal
The test was carried out to verify the marking performance of the UV Pro 5W UV laser on agate. The required result was a clear visible design with a good final appearance.
2. Test Requirement
The sample material was agate. The marking process needed to produce a clean decorative pattern on the surface.
3. Machine and Material Setup
| Item | Details |
|---|---|
| Machine type | UV laser |
| Machine model | UV Pro 5W |
| Software | Raycraft |
| Material | Agate |
| Application | Decorative surface marking / customization |
| Process | Laser marking |
| Processing time | 20 min |
| Test result | Good |
4. Laser Parameter Used
| Parameter Item | Value |
|---|---|
| Marking mode | Flat engraving |
| Speed | 500 mm/s |
| Frequency | 60 kHz |
| Pulse width | 1 |
| Marking times / Pass count | 5 |
6. Test Conclusion
This agate marking test achieved the required visual effect using the UV Pro 5W. The result shows that the machine can produce detailed decorative marking on an agate surface for sample customization and visual design testing.
This type of result may be useful for personalized ornaments, craft products, decorative gifts, and small-batch custom stone accessories. Before batch production, the final parameter values should be confirmed with the same material, artwork file, lens setup, and marking software.
