This test used a UV-10 UV laser to mark a lighthouse landscape image on plywood, exploring a decorative application for bitmap artwork.
1. Test Goal
Evaluate whether the selected setup could produce a satisfactory surface image from the supplied landscape artwork.
2. Test Requirement
Mark the supplied lighthouse scene, including its surrounding palm trees, buildings, and sky, onto the sample. The task was image marking, not cutting or deep relief engraving.
3. Machine and Material Setup
| Item | Details |
|---|---|
| Machine type | UV laser |
| Software | Lightburn |
| Material | Plywood |
| Application | Decorative landscape image |
| Process | Bitmap image marking |
| Processing time | 22 minutes |
| Test result | Rated good |
4. Laser Parameter Used
Parameter completeness: Complete
| Parameter Item | Value |
|---|---|
| Layer mode | Image |
| Speed | 300 mm/s |
| Maximum / Minimum power | 20% |
| Frequency | 80 kHz |
| Q-pulse width | 12 ns |
| Line interval | 0.0330 mm |
| Resolution | 769 DPI |
| Pass count | 1 |
| Scan angle | 0 degrees |
| Image mode | Jarvis |
| Bi-directional scanning | Enabled |
| Negative image | Disabled |
| Pass-through | Disabled |
| Fill order | Fill all shapes at once |
| Dot-width adjustment | Disabled |
5. Test Result
Processing was completed in 22 minutes, and the test received a good result rating. A finished-sample photograph is not available in the supplied materials, so visual contrast, fine-detail reproduction, and surface condition cannot be assessed here.
6. Test Conclusion
The UV-10 test provides an initial reference for decorative image marking on plywood. The application may be relevant to personalized picture panels and craft products, with finished-image quality still requiring photographic confirmation.
Before batch production, the final parameter values should be confirmed with the same material, artwork file, lens setup, and marking software.
